I've had these in my bronco for quite a while now and one of the bearings needs to be replaced. Can I reinstall a seal and use the factory bearing or do I have to use a specific tapered roller bearing? View answer
Asked 5 ´years ago | Ford 9-inch Rear Axles | 31-Spline, Large Bearing, 11 inch | 66-75 Ford Bronco
I have a 74 chevy dana 44 front axle with rcv's and was wondering if these would fit and would the rcv slide through the center hole? I don't mind converting everything to ford from the knuckle out as long as the rcv slides out the center hole, Chevy knuckles don't allow this and its a pain to service my carrier with my current setup<br>Thanks for your time View answer
Asked 2 ´years ago | Reid Racing Flat Top Extreme Duty Dana 44 Knuckles | PAIR | Ford
What psi does this pump put out? I have hydro boost brakes and am concerned. Also does this pump have a lower mounting location on the back of the pump? Most saginaws do, just confirming. Lastly, is this the same as your 2012a pump....the sag pump with dual returns and no pulley? This is going on a 1979 bronco with a 460. Thanks View answer
Asked 10 ´months ago | IDIDIT Direct Fit Tilt Column, Chrome, A/T Column Shift, 76-77 Bronco
I understand that there muse be holes drilled in to the rocker panel. But what is it that the screws are actually attaching to? The thin metal of the rocker? Or is there a way to get a nut in there? View answer
Asked 4 ´months ago | Full Length Rock Rails with Nerf Bar, 1/4' Steel (pair), 66-77 Ford Bronco
Does the 164 tooth flywheel require a bell housing from 1981 or later or can I use the original bell housing. Swapping from early 289/3spd to 99' 5.0 and NV3550 and want to reuse the bell housing if possible.<br><br>Thanks View answer
Asked 1 ´year ago | 80-96 Ford Bronco & Truck Accessories > Clutch Flywheel | 50 oz Balance, 164 Tooth | SBF 5.0L V8 | 66-77 Ford Bronco
