I have the trac bar riser for the dana 30 and it works great. problem is the axle bump stop that's there now is to short as the axle is about 6 away or so. I do not see anything about a replacement solution for this on your site. View answer
Asked 6 ´years ago | Speedometer Cable | OE-Type, 72.5-inch | 66-77 Bronco, 57-72 Ford Truck
Black open will center cap View answer
Asked 6 ´months ago | Black Front Wheel Center Cap | Open | 4.25 inch Diameter
I forgot to ask, what are the dimensions of this bag? View answer
Asked 3 ´years ago | ARB Recovery Bag
My stock lower alternator bracket runs very close to the lower radiator hose. Is this alternator the same center to center bolt pattern as the stock alternator on my old '67 with a 302 engine? Will be a clearance problem if it is larger. Thank you. View answer
Asked 3 ´years ago | 3G Alternator | One-Wire, High Output, 90/130 Amp | 66-77 Ford Bronco
I want to upgrade my alternator, from the original Ford alternator to your High output alternator part #6013. I understand the new alternator hooks right up to the battery with one large wire. My question is what do I do with the voltage regulator, the capacitor and all the wires that were hooked up to the old alternator? View answer
Asked 1 ´year ago | 3G Alternator | One-Wire, High Output, 90/130 Amp | 66-77 Ford Bronco
Does it have the hole for the dome light View answer
Asked 6 ´months ago | Wiper Motor Cover | Black | 69-77 Ford Bronco
Does the 164 tooth flywheel require a bell housing from 1981 or later or can I use the original bell housing. Swapping from early 289/3spd to 99' 5.0 and NV3550 and want to reuse the bell housing if possible.<br><br>Thanks View answer
Asked 1 ´year ago | 80-96 Ford Bronco & Truck Accessories > Clutch Flywheel | 50 oz Balance, 164 Tooth | SBF 5.0L V8 | 66-77 Ford Bronco
