I'm doing the install on the 6129 harness. I am trying to figure out the wire connections for the yellow connector (white red and black wires). I don't have the female connector in the spaghetti of what the prior owner left me in the vehicle). The ground is pretty straight forward but not sure about the other two wires? <br>Thanks! View answer
Asked 6 ´years ago | Night Lighter Headlight Harness | Extreme Duty | 66-79 Ford Bronco
I purchased the billet steering column shift collar, and was wondering when I go to install it do I need to leave out the shift tube? It doesn't look like there is a way to retain it, not that I would need it for anything. Any hints on installing everything back together.<br><br>Thanks,<br><br>Brent View answer
Asked 1 ´year ago | Front Bucket Seat Back Trim Panel | OE Parchment Plastic | 68-77 Ford Bronco
What is the difference between this spring and the early bronco 5.5 spring (p/n 1005)? Seems the length as well as the rate are the same. Trying to decide which to use in a small block buggy project. Thanks! View answer
Asked 6 ´years ago | WH All-Terrain Coil Springs | 4 inch Lift | 78-79 Ford Bronco, 66-79 F150 4x4
Does the 164 tooth flywheel require a bell housing from 1981 or later or can I use the original bell housing. Swapping from early 289/3spd to 99' 5.0 and NV3550 and want to reuse the bell housing if possible.<br><br>Thanks View answer
Asked 1 ´year ago | Clutch Flywheel | 50 oz Balance, 164 Tooth | SBF 5.0L V8 | 66-77 Ford Bronco
What psi does this pump put out? I have hydro boost brakes and am concerned. Also does this pump have a lower mounting location on the back of the pump? Most saginaws do, just confirming. Lastly, is this the same as your 2012a pump....the sag pump with dual returns and no pulley? This is going on a 1979 bronco with a 460. Thanks View answer
Asked 1 ´year ago | IDIDIT Direct Fit Tilt Column, Chrome, A/T Column Shift, 76-77 Bronco
