Question 1

What are the dimensions of the core: height, width, and thickness? Also, what size are the 120 tubes? I would like to see how the heat transfer surface area compares to that of the stock radiator as well as how much closer the core will be to the fan. View answer

Asked 3 ´months ago | WH Staggered 4-core Radiator, SBF V8, 66-77 Ford Bronco - Made in USA

Question 2

What are the dimensions so I can plan my dash layout? Thanks View answer

Asked 2 ´years ago | Gas Pedal Link Rod | SBF 289 302 351W V8 | 66-77 Ford Bronco

Question 3

I have an old Wild Horses 3.5 lift kit from 20 years ago with the full-length add-a-leaf, slipped into the stock leaf stack. Would this kit be a good replacement for that setup? Would it be approximately the same height? View answer

Asked 5 ´years ago | ARB Compact Air Compressor

Question 4

I am trying to determine if a double DIN headhunt will fit, what is the dimensions of the opening? View answer

Asked 2 ´years ago | Chrome Window Moulding Trim Kit | 66-77 Ford Bronco

Question 5

Does the set come with arm rest covers for the back seat? View answer

Asked 5 ´years ago | Parchment Seat Upholstery Set+ Foam | Front & Rear | 68-77 Ford Bronco

Question 6

Is this 18 or 20 gauge steel? View answer

Asked 6 ´years ago | Rocker Panel | OE-Type, SINGLE | 66-77 Ford Bronco

Question 7

is this for a pair View answer

Asked 1 ´year ago | LED Tail Light Board Conversion Kit, 66-77 Ford Bronco

Question 8

I have done a hydroboost conversion on my 78 F250. Do you offer a reservoir with two return ports? View answer

Asked 5 ´months ago | Power Steering Pump | 351M 400M | 78-82 Bronco, 77-82 Ford Truck

Question 9

I bought a project pile of '66 parts 2 yrs ago. I believe the doors are original '66 as the window frames bolt on. I've read the striker location may be different on '69 and newer. Is has been a frame off restomod and has been painted and body mated to the chassis now. Ready to build up the doors. Will this 68-77 kit fit my early doors? If not do you have a kit for the earlier doors? View answer

Asked 3 ´years ago | Master Door Parts Kit - No Door Shells | Driver & Passenger | 68-77 Ford Bronco

Question 10

Are these Timken bearings or standard? View answer

Asked 4 ´years ago | Large Rear Axle Bearing | 66-77 Ford Bronco, 53-79 Ford Truck

Question 11

Do ya have the matching back mats? View answer

Asked 4 ´months ago | AX15 Transmission to Dana 20 Conversion Kit | No Transmission | 66-77 Ford Bronco

Question 12

Have an 87 5.0 with serp setup. Will this work with part # 2032 PS pump bracket, 2030 PS cooler and 2062 PS serp pulley? View answer

Asked 3 ´years ago | Dana 30 King Pin Rebuild Set | Upper or Lower | 66-71 Ford Bronco

Question 13

can i order the tank with efi set up and use it for carb until i get efi for it? View answer

Asked 5 ´years ago | M1A1 Stainless 23 Gallon EFI Fuel Tank + Strap Mount | In-tank Pump | 66-77 Bronco

Question 14

What is the difference between the BIL88013 & Bil88011? View answer

Asked 5 ´years ago | Bilstein 5100 Shock - Eye/Eye, 26' Extended, 16' Compressed

Question 15

what rear u joint do these come with View answer

Asked 4 ´years ago | High Clearance HD Rear Driveshaft | 66-77 Ford Bronco - Made in USA

Question 16

What type of power steering fluid and how much in the reservoir? View answer

Asked 5 ´years ago | Hydroboost Braking System, 65-79 Ford F-Series/ 78-79 Ford Bronco

Question 17

Does this kit include enough rings to refinish both driver and passenger side? View answer

Asked 5 ´years ago | Hog Ring Pliers + Hog Rings | Upholstery Tool Kit

Question 18

will the high pressure of this pump make the 4x4x2 steering box feel twitchy on the road at highway speeds? It seems like the pressure for Ford steering is supposed run at a lower PSI and GPM than General Motors. View answer

Asked 1 ´year ago | Yukon Dana 44 Super Joint Kit | 4340 Chromoly, PAIR | 78-79 Bronco, 73-79 Ford Truck

Question 19

I have a set of Western Turbine 15 wheels, will these clear the calipers on the conversion kit? View answer

Asked 1 ´year ago | Front Disc Brake Conversion | Dana 30/44 | 66-75 Ford Bronco

Question 20

For future replacement, what are these brakes based on? View answer

Asked 3 ´years ago | 4-wheel Power Disc Brake Kit | Vacuum Boost | 67-75 Ford Bronco

Question 21

Does this fit existing holes on a 1987 full size bronco? View answer

Asked 1 ´year ago | Black Chrome Bucking Bronco Emblem | Stud Mount | 4.25-in x 3-in

Question 22

Which filler hose do I need for the M1A1 tank? View answer

Asked 4 ´years ago | Rear Main Fuel Tank Filler Hose | 66-77 Ford Bronco

Question 23

will your amp to volt replacement gauge work in my 1985 Bronco II View answer

Asked 4 ´years ago | Voltage Gauge | Fits Stock Cluster | 66-77 Bronco, 61-66 Ford Truck

Question 24

Will<br>These fit the AOD ? View answer

Asked 6 ´years ago | C4 Automatic 6AN Cooler Line Fittings | 6AN x 1/8 NPS | 73-77 Ford Bronco

Question 25

if these 15x7 wheels with a 3.75 backspace fit a 76-77 bronco with a 1/4 spacer, then shouldn't a 15x8 wheel with a 4 backspace fit a 76-77 bronco with a 1/2 spacer? View answer

Asked 5 ´years ago | US Mags Indy Wheel | 15x7 | 5x5.5 Bolt Pattern

Question 26

Will this rebuild kit also work with a stock pinion support that will be installed in a 35 spline carrier housing? View answer

Asked 3 ´years ago | Third Member Rebuild Kit | 35 spline, Daytona | LM104949/LM104911

Question 27

Is this the standard rotation pump for v-belt setups? View answer

Asked 2 ´years ago | FlowKooler Water Pump | SBF 289 302 351W V8 | 66-77 Ford Bronco

Question 28

Does the new AX 15 transmission come with a warranty? View answer

Asked 3 ´years ago | AX15 Kit with Brand New Transmission For 66-72 Bronco T-Shift Dana 20

Question 29

What bolt pattern are these shafts? View answer

Asked 1 ´year ago | Ford 9-inch Rear Axle Shafts | 35-spline, PAIR | 78-79 Bronco, 73-79 Ford F150 4WD

Question 30

Does this wire in with the existing wires and does it work with back up light? View answer

Asked 4 ´years ago | LED Tail Light Board Conversion Kit, 66-77 Ford Bronco

Question 31

Will this fan shroud work with a 1inch body lift? View answer

Asked 1 ´year ago | Full Circle Aluminum Radiator Fan Shroud | SBF V8 | 66-77 Ford Bronco

Question 32

What is the size of the flanged fitting on the cooler lines? I purchased the AN-6 x 1/4 NPT fittings and the 1/4 NPT fit in the Ron Davis aluminum radiator but the AN-6 was too big for the cooler line. Bought an AN-4 and that was too small? View answer

Asked 4 ´years ago | Ford C4 Auto Trans Cooler Hard Lines | Stainless | 73-77 Ford Bronco

Question 33

Does this eliminate the seat belts then? View answer

Asked 4 ´years ago | Fender & Grille Emblem Badge Kit | Black Chrome | 66-77 Ford Bronco

Question 34

Good morning , do the spark plug boots go in before headers are installed . View answer

Asked 1 ´year ago | Silver Spark Plug Boot Protectors | Set Of 8

Question 35

Is this dip stick flexible to bend around my headers? How does the top of the dip stick mount? View answer

Asked 2 ´years ago | Engine Oil Pan Kit + Stainless Dip Stick & Tube | SBF 289 302 V8 | 66-77 Ford Bronco

Question 36

Hi, I have new dual electric WW conversion, Will this cover work with the new dual WW Wipers? View answer

Asked 2 ´years ago | Revolution LED Headlights | Black w/Halo, 7" Round | 66-78 Bronco, 48-78 Ford Truck

Question 37

Will these work on a 3/8 fuel line? I thought the original nylon line was 5/16 but I have 3/8 View answer

Asked 3 ´years ago | Billet Aluminum Battery Hold Down | Anodized | 66-86 Bronco, 65-86 Ford Truck

Question 38

How tall and wide are these letters? View answer

Asked 11 ´months ago | FORD Grille Letters | Chrome + OE Red Inserts | 67-77 Ford Bronco

Question 39

Does this column have a 4-way flasher switch like the Ididt 76-77 Bronco retrofit column? Does anything need to be changed for a 1 body lift? View answer

Asked 4 ´years ago | Tilt Steering Column Kit with Automatic Column Shifter | Custom Built

Question 40

Do you retain the factory transfer case cross member and mount location? View answer

Asked 3 ´years ago | Dana 20 Transfer Case Adapter | Ford 6R80 4WD Automatic | Coyote Swap

Question 41

My 1975 Bronco has always leaked where the stock slide-in dip stick tube connects with the oil pan. To use the screw-in dip stick tube, I'll need to buy a whole new pan that has the threaded female connection, right? Or is there another way? View answer

Asked 5 ´years ago | Screw-in Oil Pan Dip Stick Tube | Passenger Mount | 289 302 | 73-77 Ford Bronco

Question 42

Do these seat belts work for the rear the rear bench seat in 70 bronco. If not , do you have a set of seat belts that will work for the rear. Thanks View answer

Asked 8 ´months ago | Derale Performance > Door Latch Rod | RH Passenger | Key/Latch | 68-77 Ford Bronco

Question 43

Will this switch work with the Painless wiring harness? View answer

Asked 1 ´year ago | Ignition Switch Kit | Switch, Spacer, Bezel & Cylinder | 66-77 Bronco, 61-66 Ford Truck

Question 44

what is the ID of the center bolt hole?<br>Thanks View answer

Asked 6 ´months ago | Speedometer Drive Gear Clip | 66-91 Bronco, 57-91 Ford Truck

Question 45

What ball joint will fit this Pittman arm? View answer

Asked 2 ´years ago | Drop Pitman Arm | 78-79 Ford Bronco, 76-79 F150 4WD

Question 46

The heater control knobs don't seem to come off. Can these knobs be made to fit those? View answer

Asked 2 ´years ago | Billet Dash Knob | OE-Look, SINGLE | 66-77 Bronco, 61-72 Ford Truck

Question 47

Does the top get narrower in the rear or is that an optical illusion of the picture? If it does narrow does the narrowing serve a purpose or is it just for aesthetics? View answer

Asked 5 ´years ago | Family Cage Black Roll Bar Top Kit, 66-77 Ford Bronco

Question 48

Can this be used for manual transmission? If not do you have one that will? View answer

Asked 3 ´years ago | Dakota Digital RTX Dash | OE-Look | 66-77 Bronco, 61-66 Ford Truck

Question 49

Can you tell me the inside width of these radiator mounts. Item # 5028<br>Thanks, View answer

Asked 5 ´months ago | Rubber Radiator Insulator Mount Bushing | 3-Core, SINGLE | 66-77 Ford Bronco

Question 50

Will these work for the stock back seat 69 bronco? Do u have any brackets to mount ? View answer

Asked 5 ´years ago | Derale Performance > Door Latch Rod | RH Passenger | Key/Latch | 68-77 Ford Bronco

Browse by Topic