In reading the answer to a previous question, it sounds like the included fuel pump runs at 90 psi. But the Edelbrock Pro-Flo 4 system requires 43-45 or 58-60 psi. Is the included fuel pump pressure adjustable, or, is there an option to order the M1A1 tank with a fuel pump that is compatible with the PF4 system to avoid using a fuel pressure regulator? View answer
Asked 4 ´years ago | M1A1 Stainless 23 Gallon EFI Fuel Tank + Skid Plate | In-tank Pump | 66-77 Bronco
Looking at these shocks for my 1974. What are the dimensions of the mounting eyelets? It states that factory mounts will not work. I currently have wild horses long travel front hoops and rear hoops with Cage arms on the front axle and no existing lower rear mounts currently. Just trying to figure out what I need to make these work? Or am I better to go with the 5165? Any suggestions? View answer
Asked 2 ´years ago | Bilstein 7100 Short Body Reservoir Shock | 360/80 | 34 inch Extended, 19.5 inch Collapsed
What length are these? View answer
Asked 6 ´years ago | Driveshaft Bolts | 66-77 Ford Bronco
Working on a build that will have a 5.5 in. lift. Noted in the specs that this works with up to 3 in. lift. Will any special modifications be needed to use this tank (including skid plate) with 5.5 in. lift? View answer
Asked 2 ´years ago | M1A1 Stainless 23 Gallon EFI Fuel Tank + Skid Plate | In-tank Pump | 66-77 Bronco
I have a 74 chevy dana 44 front axle with rcv's and was wondering if these would fit and would the rcv slide through the center hole? I don't mind converting everything to ford from the knuckle out as long as the rcv slides out the center hole, Chevy knuckles don't allow this and its a pain to service my carrier with my current setup<br>Thanks for your time View answer
Asked 3 ´years ago | Reid Racing Flat Top Extreme Duty Dana 44 Knuckles | Pair | Ford
I've had these in my bronco for quite a while now and one of the bearings needs to be replaced. Can I reinstall a seal and use the factory bearing or do I have to use a specific tapered roller bearing? View answer
Asked 5 ´years ago | Ford 9 inch Rear Axles | 31 Spline, Large Bearing, 11 inch | 66-75 Ford Bronco
