I have a 1969 and am getting ready to install an AOD in place of a 3spd column shift. I would like to keep the stock steering wheel. Can this column be used on a '69? If so, what will have to be modified? View answer
Asked 2 ´years ago | IDIDIT Direct Fit Tilt Column, Black, A/T Column Shift, 76-77 Bronco
How many wires are in the set. View answer
Asked 5 ´months ago | PerTronix Flame-Thrower 8.0 mm Spark Plug Wires | Red
Is this the only pump you need to run stock efi, or do you have to use a high volume low pressure pump to pull the fuel out of the tank to supply this one? I have done one other efi swap before and had to use two pumps, one to draw the fuel out of the tank and one to supply the high pressure to the fuel rail. View answer
Asked 4 ´years ago | EFI Frame Mounted Fuel Pump | 125 psi | 38 gph (144 lph)
Will this work with 3/8 fuel line? View answer
Asked 11 ´months ago | In-line Fuel Pressure Gauge Fitting | 1/8 NPT
Want to see if and get prices on body bushing with hardware for my 77 bronco and my hardware will have to be for a two inch body lift Also I only need bushing and bolts because two inch body lift is already on truck. Thanks View answer
Asked 10 ´months ago | Tremec TR4050 Transmission Mount | Urethane
So my bronco has no wiper parts what so ever and i need to buy them. Im having some confusion on what parts to buy. Iv seen the one motor set up with the linkage. I think mine is 1967 which had the vacume motors. Can i buy this 2 motor set up and eliminate the linkage? Thanks View answer
Asked 2 ´years ago | Synchronized Electric Windshield Wiper Kit | Dual Motor | 66-77 Ford Bronco
Do I still use the spacer if I use your heavy duty axle retaining plate? The instructions appear to depict using the spacer with a heavy duty axle retaining plate in the last photograph. However, the first page of the instructions (the line drawing) makes it look as though the spacer is only used with the OEM axle retaining plate. View answer
Asked 1 ´year ago | 2-Port USB Round Socket for Custom Mount
Will this fit a 1997 4 wheel drive XLT View answer
Asked 4 ´years ago | Tremec TR4050 Transmission Mount | Urethane
How many amps does this provide? View answer
Asked 1 ´year ago | Dual USB Charger Outlet for Custom Mount
I have a 1977 Ford Bronco that has been setting up for about 2 months. I went to start it on Saturday but it will not stay running when I release the key from the start position it dies hold it in the start position and it will crank let go of the key and it dies. Is this a bad ignition switch? View answer
Asked 6 ´years ago | Ignition Switch Kit | Switch, Spacer, Bezel & Cylinder | 66-77 Bronco, 61-66 Ford Truck
