Do you have a 1.5 - 2 leveling block for the front end coil springs to take the rake out? I also have a clearance problem with my 33 tires rubbing on the front edge of the fenders when turning. I already trimmed a little off the fenders and can trim a little more but I was wondering if you had a leveling block. View answer
Asked 2 ´years ago | Racket Jacket Wheel Well Insulation Kit | 66-77 Bronco
Is this a Chinese-made jerry can? View answer
Asked 10 ´months ago | NATO Fuel Jerry Can | Red | 2.5 Gallon - 10L
I notice that you sell a more powerful heater motor/fan to upgrade old heaters. Does this brand new system include a more powerful or efficient motor/fan? Or is it just a brand new (original spec) box? View answer
Asked 1 ´year ago | Heater Box Kit with Stock Blower Motor | OE Type | 66-77 Ford Bronco
I have a 1979 ford f150 four wheel drive with play in the steering u joint.<br>The lower shaft has a wrag joint.<br>Will this Adjustable Lower Steering Shaft - 78-79 Bronco 73-79 F150<br>Item #: 792161 fit my truck and replace the rag joint? Thanks Todd View answer
Asked 4 ´years ago | Collapsible Lower Steering Shaft | 78-79 Bronco, 73-79 Ford F150
I now have an older 3.5 lift on my 70EB. I'd like to change to your new 2.5 lift with Bilstein shocks. Do I need to worry about my drive line being too long with lower lift? If I do, how do I check this measurement? Thanks, BA View answer
Asked 1 ´year ago | Early Bronco 3.5 inch Suspension Lift Kit | Bilstein Shocks
Will this fit a 1985 k10 View answer
Asked 2 ´years ago | Tremec TR4050 Transmission Mount | Urethane
Hi there. I am wondering which e-brake cables to get to mate with 11-inch Explorer disc brakes on a new 9-inch Currie axle that I just ordered. The e-brake setup on that unit is a drum, so I am assuming to get Part No.s 1583 and 1594. Can you confirm that these will work? I have 3.5 inch lift on this truck. Thanks! View answer
Asked 4 ´years ago | Heater Switch Cable + Bezel, Nut & Knob | 68-77 Ford Bronco
Do you sell longer T-bolts to compensate for the extra thickness of the primary mounting plate? Once I install the primary mounting plate along with your thicker after market axle retainer plates my lock nuts are only about 50% threaded onto the T-bolts. Might want to consider adding these to the rear disc brake kits. View answer
Asked 2 ´years ago | 2 Port USB Round Socket for Custom Mount
