I purchased and installed this setup a few years back.. What size ball-joint (O.D.) does this setup have where the tie-rod connects to the drag-link? Looking to order one of those bushing called the cure to eliminate the dead-band in the steering. There are (2) sizes... 3/4 or 5/8 View answer
Asked 5 ´years ago | Power Steering Conversion Kit | Quick Ratio | 66-77 Ford Bronco
I'm looking to upgrade calipers and rotors on my 69 bronco. It went through a front disk brake conversion at some point and has an Adelco Moraine 5470 caliper. Will this replace that? What rotors would I need to replace those as well? View answer
Asked 5 ´years ago | Wilwood GM D52 Dual Piston Calipers | Red, PAIR | 140-11290-R
Do nuts come with the new yoke? View answer
Asked 5 ´years ago | Transfer Case Yoke | 66-77 Ford Bronco
My 1975 Bronco has always leaked where the stock slide-in dip stick tube connects with the oil pan. To use the xxxx -in dip stick tube, I'll need to buy a whole new pan that has the threaded female connection, right? Or is there another way? View answer
Asked 5 ´years ago | Screw-in Dip Stick Tube | Passenger Mount | 289 302 | 73-77 Ford Bronco
I am in the process of putting a 1966 U13 Bronco Roadster (Budd Body) back on the road. Which product would give me a more authentic look and fit? The single piece inserts or the ones that come with the hardware kit. Thanks in advance. Peter View answer
Asked 5 ´years ago | Fiberglass Door Inserts with Backing Plates, 66-77 Ford Bronco
can you get in black View answer
Asked 5 ´years ago | Dual Return Power Steering Pump Remote Reservoir + Hoses
I've had these in my bronco for quite a while now and one of the bearings needs to be replaced. Can I reinstall a seal and use the factory bearing or do I have to use a specific tapered roller bearing? View answer
Asked 5 ´years ago | Ford 9-inch Rear Axles | 31-Spline, Large Bearing, 11 inch | 66-75 Ford Bronco
can this tank be used with a carburetor with the in tank fuel pump? I have intentions of doing efi, just not immediately. Or would i be better with the non in tank pump version until i do efi? View answer
Asked 5 ´years ago | M1A1 Stainless 23 Gallon EFI Fuel Tank + Skid Plate | In-tank Pump | 66-77 Bronco
Looking at these shocks for my 1974. What are the dimensions of the mounting eyelets? It states that factory mounts will not work. I currently have wild horses long travel front hoops and rear hoops with Cage arms on the front axle and no existing lower rear mounts currently. Just trying to figure out what I need to make these work? Or am I better to go with the 5165? Any suggestions? View answer
Asked 5 ´years ago | Bilstein 7100 Short Body Reservoir Shock | 360/80 | 34-in Extended, 19.5-in Collapsed
Are these sport-mode shifters are available for several applications in different shifter lever lengths and xxxx styles?<br><br>Is this kit complete or is there anything else we need to order for a EB outside of the boot and ring? View answer
Asked 5 ´years ago | Lokar 6R80 Automatic Electronic Sport Mode Shifter
